1, high speed steel coil slitting line test run form

Foot after the start of the operation, the operation state, then step on the foot to stop the operation, still need to continue the operation to step on the foot, press the stop button to stop the operation.

Test machine clarification: The test machine can only be used for air transport of the machine, not for processing! Please be careful! Except for all pedal movements at the beginning, the test run saves only all pedal movements. The other action process is the same as the formal production. After the operation begins, the action will continue to cycle until the count equals the set amount, or the button is considered to be paused.

2, semi-automatic form

Pedal to start operation. When the high speed steel coil slitting line is in working condition, if the foot is stepped down again, the action is paused. If you still need to operate, step down again and press the pause button to stop the operation. An operating procedure allows two pedal operations to be completed, i.e. the operation starts once and the tube is taken once.

3. Manual form

high speed steel coil slitting line Pictures can only be made after entering the manual pipe cutter. The key on the side of the action clarification can perform the corresponding action. When the action is complete, it is determined by the set time and then displayed as "in place".

4, fully automatic form

Pedal to start operation. When you set foot again, you will stop working. If you still need to continue working, you will step on the foot again and press pause to stop working. The operation process needs to be completed once, that is, the operation starts once.

high speed steel coil slitting line https://www.slitting-machine-maker.com/informationclass_26/information_81.shtml